Go to Top

Tag Archives

Tag Archives: pattern quality

Pattern Types

Patterning is one of the basic tasks of designing tensile membrane structures. It is also one of three modules of WinTess software shown in top bar. The usual way to transform a warped curved surface in flat strips (patterns) is doing by triangulation. It is the easiest and most used way. In another post in this blog (cross compensation) we already discussed triangulation of patterns. Given that membrane is delivered …Read More

Cross compensation

The common way of patterning of a tensile membrane is to break down to triangles which are always flat (see the below figure). This series of adjacent triangles is called as pattern. It is obvious that the triangles are defined by the sides, and these are straight segments while the membrane surface is curved (almost always double curvature). Therefore triangles are always smaller than the area representing membrane. The program …Read More